How to maintain the powder packaging machine?

The application range of the powder packaging machine is very wide. We must know the maintenance method of the powder packaging machine before use. Only then can we better apply it. If you are interested in this topic, let's have a look at it. I hope it can help some relevant people.

The powder packaging machine is widely used in various industries, so its use must be very wide. It can also be seen in many industries. In addition, all the powder packaging machine needs to do during maintenance is to oil and lubricate, and also to regularly oil its gear mesh, bearing oil hole and moving parts. It is forbidden to use the reducer once per shift. Oil-free operation. When adding lubricating oil, pay attention not to put the oil tank on the rotating belt at this time to prevent slipping and loss of rotation or belt damage due to premature aging. It is also important to note that the reducer cannot operate in the case of oil shortage, and after 300 hours of operation, clean the inside and replace with new oil, and then replace the oil every 2500 hours of operation. Do not drop oil on the drive belt when adding lubricating oil, otherwise the powder packaging machine will slip and lose rotation or the belt will be damaged prematurely. When maintaining the powder packaging machine, it should be cleaned frequently. Of course, the metering part must be cleaned in time after shutdown, and the heat-sealed body should also be cleaned frequently, especially some granular packaging materials with high sugar content.

The turntable and discharge door can be cleaned first. The main body of the heat sealing machine also needs to be cleaned frequently. The cleaning part is to ensure that the sealing line of the finished product packaging is clear. The scattered materials shall be cleaned in time to facilitate the cleaning of parts and prolong their service life. At the same time, the dust in the electric control box should be cleaned frequently to prevent electrical faults such as short circuit or poor contact. The powder packaging machine will also be maintained during maintenance. The maintenance of the powder packaging machine is one of the keys to extend the service life of the packaging machine. Therefore, it is necessary to check the screws of each part frequently to ensure that there is no looseness, otherwise the whole machine will be affected. Normal remote control rotation, or attention should be paid to the waterproof, moisture-proof, anti-corrosion and rat-proof of of its electrical parts, to ensure that the inside of the electric cabinet and the wiring terminals are clean, so as to avoid electrical failure. The sealing device body is in the open position to prevent the packaging material from being scalded. Clean and fasten machine parts; Be familiar with the use method and operate according to the instructions. Secondly, it is necessary to check whether the grounding of the powder packaging machine is in good contact to ensure power safety. Then check the engine, clutch, transmission, transmission parts, steering and braking parts of the powder packaging machine; Detect, adjust and eliminate hidden dangers, and balance the wear of all parts. In short, its special maintenance is divided into seasonal and inactive.

The above article is about the maintenance method of the powder packaging machine for all friends, and it also shares a good manufacturer in the content. If you have any needs in this aspect, you can check it, I hope it can help you.